Name: YLL Induction Heater 3.0 for DynaVap Vaporizers
Brand: DynaVap
SKU: gxy1790045600080
Price: 78.69 USD
Availability: InStock

YLL Induction Heater 3.0 for DynaVap Vaporizers

$78.69

$78.69 $129.00

YLL Induction Heater 3.0 for DynaVap Vaporizers

$78.69

$78.69 $129.00

YLL Induction Heater 3.0 for DynaVap vaporizers

The YLL Induction Heater 3.0 is an upgraded induction heater for flameless sessions with DynaVap vaporizers. Set the wattage, insert your DynaVap, and wait for the ‘click’! No twirling or torch-wielding required.

Upgraded heater

The YLL Induction Heater 3.0 packs some serious upgrades to take your sessions further:

- Larger heating chamber fits bigger tips like the HyperDyn
- Increased battery capacity with dual 21700 batteries
- Wider power range from 30W to 100W
- Premium walnut top and side panels
- See-through window for precise depth adjustment

Flameless heating with adjustable wattage

Enjoy torchless heating with the YLL Induction Heater 3.0. Insert your DynaVap vaporizer and heat it up in less than 30 seconds without a live flame or spinning and rotating.

This induction heater also comes with adjustable wattage to control how fast or slow your DynaVap heats up and ‘clicks.’ Set the wattage in 5-watt increments, from 30W to 100W.

Wattage & Heating Starter Guide

Wattage controls how quickly your device heats and can have a big impact on the extraction. Your ideal setting will vary depending on your cap, tip, heating depth, and preferred vapor style.

Standard Cap (Captive Cap): Start around 30W to 40W for a slower, more controlled heat-up and fuller extraction. If heating feels too slow, gradually increase the wattage.

Faster Heating: Try 65W to 70W for quicker heat-up times. If the vapor feels too light or the heater reaches the click too quickly, lower the wattage or adjust the heating depth.

Larger or Armored Caps: These setups have more thermal mass and may require different wattage, depth, and heating times. Start conservatively and make small adjustments until you find the right balance.

Once you've found a wattage you like, fine-tune the chamber depth to focus the heat where your tip carries the most mass. Then adjust the timer to match your typical click time.

Tip: Start at one end of the wattage range, see how your setup responds, then adjust in small increments. Every tip and cap combination behaves differently, so a little experimentation goes a long way.

Adjust the chamber depth

Adjust the heating chamber's depth to dial in specific heating profiles. Extend the chamber to heat your DynaVap from the tail-end of the cap and create denser vapor. Shrink the chamber and heat it more towards the top of the cap for quicker heat-ups and gentler extractions. Use the window to see and mark exactly where you’re at.